I think it is official I'm an idiot.

[TrialByFir3]

long story short we bought a used DTIM8 power it up and all DKT lights come on and stay on. I connect a serial cable to see if I can tell what is going on and "#### WARNING, DSP IS IN DOWN STATE!!! CHECK BOARD!!! ####" is scrolling non stop.

Please help

 

[xs650]

Do you can stop booting by pressing CTRL C right after powering on the module?
When this is possible you could try to do a recover.

But I don´t know if this would help cause I never have seen this message...

 

[TrialByFir3]

I can CTRL C but in all the options I do not see a recover. is this something someone with little experience can do? or do you have a link to some instructions for this?

 

[montyzummer]

connect to the mpb of the system not the dtim go in through login of brandy and contact me q u a k e r at hotpost dot com

APSS (SME)
ACSS (SME)
ACIS (UC)

 

[TrialByFir3]

Montyzummer, I tried to contact you but received an undelivered response.

 

[montyzummer]

q u a k e r 2 1 a t h o t m a i l d o t c o m my bad

APSS (SME)
ACSS (SME)
ACIS (UC)