I have psuedo (phantom) numbers that may dial 911. 1

[gary454]

How do I change the appearance of the psuedo numbers to the main number of a branch?

 

[a12ozbottle]

At the didn prompt they are probably set to yes, which means they will send out the dn that you are calling from.
The best way would be to create a new entry in ld 15
chg
net
clid yes
entry= one that is not used

Can't remember the rest off the top of my head but you can find it under ld 15 net_data in the input output guide.

Then make the change to the phones key x 1234 y or dn 1234 y
y=new table entry.

 

[dcrocker22754]

My switch has the following information:

HNTN = NPA
ESA_APDN = YES
HLCL = NXXXXXX
CLASS FMT = DN

When a call goes out from my system, this number is generated and gives the e911 the location the call is coming from. However, since I have remote sites all over, the caller has to be able to give the operator specifics. I dont all the ins and outs of e911, but it seems to me that you would have to provide the 911 center with these non-did numbers and the location of these numbers within your site. If your site is single location, no problem, but if you are multi-location, there is where the situation could get sticky.

Benjamin Crawford
Presidio Corp
Richmond, VA

 

[a12ozbottle]

Well the way it sounds like it is set up now he is sending a nxx plus the non did dn. The operators will see this number and it may belong to someone else.

Gary can you post your tables for us?

 

[gary454]

REQ: PRT
TYPE: CLID
CUST 0
SIZE 256
RNGE

INTL

ENTRY 0
HNTN 254
ESA_HLCL 501
ESA_INHN NO
ESA_APDN YES
HLCL 501
DIDN YES
HLOC
LSC
CLASS_FMT DN

ENTRY 1
HNTN 254
ESA_HLCL 200
ESA_INHN NO
ESA_APDN YES
HLCL 200
DIDN YES
HLOC
LSC
CLASS_FMT DN
These are the tables.

 

[a12ozbottle]

Ok, build an entry 2 with the main number nxx, didn-no, and I think it is hloc=main dn, then assign it to the dns you are referring to. That will send out the main number when you are dialing out.

 

[gary454]

Thanks, a12, your help is greatly appreciated!!