I have a new customer I just installed a MICS 6.0 it has a Valcom 3 zone page. Right now I press F62/1/2/3/4 for zones or all page that works O.K. what I would like to do is put all page(phones) and all page(external speakers)under a button. I do not want to put it on a co line.The valcoms 4 zones are areas 1,2,3 and then 4 for all page. can I program a button for f63 (to get the phones and loudspeakers) and then have them press 4 to get the 3 zones of the valcom ? Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
I have a new customer I just instal
- Thread starter mrtelec
- Start date
allworxguy
Vendor
- Thread starter
- #3
Actually, I hit it with Feature 630 programmed on a button and then press 1 through 4 for the valcom codes, being that all page on the valcom is 4.I hit the button and it shows all sets and spkrs, then press 4 and it hits the all zone. Works great. I forgot I had to do the 0. Thanks
If you upgrade to R6.1 or higher you will get DTMF over the paging port.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
Correction to my last post. DTMF over the page port started at R4.0. I had R6.1 stuck in my head for some reason.
Brian Cox
Oregon Phone
Brian Cox
Oregon Phone
- Status
Similar threads
- Locked
- Question
