Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

I have a 4 node Rolm Mod 70 9751. I have to remove Node 4 in the next few days. 1

Status
Not open for further replies.

mookie86

Technical User
Dec 8, 2010
7
US
I have a 4 node Rolm Mod 70 9751. I have to remove Node 4 in the next few days.
Node four is connected via XDI, XDI to CPNRI, to CPNJ, to CPNI.
What commands do I use to tell configuration that NODE 4 is no longer needed in the topology of this PBX - when we down the link node 4 drops off and CNFG can't be updated due to node 4 being offline.
Thanks
 
Does the Mod 70 still have p-cnfg? You will probably have to delete the node 4 links
 
I think p-config was last used with 9004 software, and hex was used for some commands like adding cards. I recall years ago we had a node that was out of service due to a fire (the water to put it out is what did it in) and of course 'Load stby mem all' would give an error message about that node. I don't recall if it the node was eventually removed via configuration or they just left it as is.
 
I found the 2 rolm diskettes that have all the manuals its in 32 bit - trying to make in work on windows 10 - we can't make any changes in cnfg since node 4 is offline. Had to up the XDI/CPN to calm her down and get back cnfg.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top