I have a 4 node Rolm Mod 70 9751. I have to remove Node 4 in the next few days. 1

[mookie86]

I have a 4 node Rolm Mod 70 9751. I have to remove Node 4 in the next few days.
Node four is connected via XDI, XDI to CPNRI, to CPNJ, to CPNI.
What commands do I use to tell configuration that NODE 4 is no longer needed in the topology of this PBX - when we down the link node 4 drops off and CNFG can't be updated due to node 4 being offline.
Thanks

 

[hamncheese]

Does the Mod 70 still have p-cnfg? You will probably have to delete the node 4 links

 

[keyset6]

I think p-config was last used with 9004 software, and hex was used for some commands like adding cards. I recall years ago we had a node that was out of service due to a fire (the water to put it out is what did it in) and of course 'Load stby mem all' would give an error message about that node. I don't recall if it the node was eventually removed via configuration or they just left it as is.

 

[mookie86]

I found the 2 rolm diskettes that have all the manuals its in 32 bit - trying to make in work on windows 10 - we can't make any changes in cnfg since node 4 is offline. Had to up the XDI/CPN to calm her down and get back cnfg.