I am unable to get the procomm software to upload file after it connects to the number. The script just stops.
Below is the code I used. Help . . .
;* CHASE.WAS *
;* Copyright (C) 2000 - 2010 Ametek Aerospace. *
;* All rights reserved. *
;* *
;* This program will trasmitt PP file to Chase Manhatten Bank *
;* *
;*****************************************************************************
;*****************************************************************************
;* *
;*****************************************************************************
proc main
dial DATA "Chase"
while $DIALING
yield
endwhile
if $CARRIER
;perform operations here once connected...
waitfor "rocomm Plus Ready!^M^J"
transmit "^M"
waitfor "Hoót Náíe: "
transmit "UserID^M"
waitfor "Enter logon id: "
transmit "Password^M"
waitfor "Enter password: "
transmit "^M"
waitfor "The current File Transfer Protocol is ZMODEM."
transmit "013004TranF.txt^M"
transmit "u"
transmit "z"
transmit "013004TranF.txt^M"
pause 2
sendfile ZMODEM "013004TranF.txt"
while $XFERSTATUS
yield
endwhile
endif