I am using a hard disk from 43p-140

[tedans]

I am using a hard disk from 43p-140 and transfer it to a 43p-150 is this ok? and will it boot directly or I will have to install it with a system backup

 

[MoshiachNow]

Hi,

It should boot without a problem,assuming it's a system dusk.

"Long live king Moshiach !"

http://www.7for70.com/

 

[tedans]

It did not boot successfully after the icons were displayed and the front panel shows E1F1 it automatically rebooted.

 

[MoshiachNow]

Then either it's contents is no good anymore or you have some HW issue.

"Long live king Moshiach !"

http://www.7for70.com/

 

[aixTim]

Check the hardware type:

p43-150 is chrp
p43-140 is RSPC

 

[unixfreak]

You probably need to rebuild the boot LV.

Cheers

 

[tedans]

Yes the hardware type are:
p43-150 is chrp
p43-140 is RSPC

does this mean that it is not compatible? and the way to have it running is to restore from a backup of the same hardware type or to reinstall AIX

 

[petertp6]

If you install a bootable disk from 7043-140 to 7043-150,
It may not be boot due to hardware kernel is not match.
You have to restore 7043-150's image tape or
boot form AIX CDROM then restore 7043-140's tape.

 

[tedans]

Yes I booted from the CDROM to restore the mksysb of the 43p-140