Hunt Groups

[bossman57]

how can I prt my hunt groups configuration?

 

[bigindian65]

ld 20
prt
ght
enter


Mato' Was'aka

 

[bossman57]

thanks, I get a SCH0443 which says list does not exist. So basically I have no hunt groups configured. Thanks.

 

[bigindian65]

future reference, in case you need it.........

HUNT GROUP
To create Hunt Groups you need to use LD18 to store the extensions in the Group Hunt List and LD57, which assigns the Pilot DN to the Group Hunt List.

LD 18
REQ NEW
TYPE GHT
CUST 0
LSNO (Next List Number)
DNSZ (Directory Number Size)
SIZE (Size of list, How many entries)
STOR 00 XXXX (XXXX = Directory Number)
WRT (C/R)
STOR 01 XXXX (XXXX = Directory Number)


Continue with store entries until list completed.

Attaching a Pilot DN (PLDN) to the list number LD 57

REQ CHG
TYPE FFC
CUST 0
CODE PLDN
PLDN (Pilot Directory Number, which must be a unique number on the Meridian)
USE GPHT (Group Hunting)
LSNO List number created in LD 18)
HTYP (RRB=Round Robin, LIN = Linear)
CFWI (NO = Skip Extn if CFW Activated
YES = Terminate on Extn if CFW Activated)
MQUE (ALL = No limit on queued Calls
0 = No calls to be queued
1 = Maximum of 1 call queued)

In order to add or remove an extn number from a group hunt list you need to know the list number (LSNO)and the store entry number (STOR within the list. You will need to use this procedure if you get a SCH8825 message when changing a TN.
You can get this information by printing the Group Hunt Lists in overlay LD 20.
REQ PRT
TYPE GHT
LSNO (c/r for all the lists or enter the list no)
Check the print out to obtain the correct information.

The changes are made in LD 18.

REQ CHG
TYPE GHT
LSNO (enter the list number which requires changing this is the GHLN from the above print out)
SIZE (c/r)
WRT (c/r)
STOR enter the store number concerned then space then the extentsion (DN) number
STOR XX YYYY for example
WRT (c/r) Yes to update the list.
To remove an entry at the STOR prompt
STOR enter the store number, space(c/r)
STOR XX space bar
WRT (c/r)
Carriage return through to the REQ prompt.
LSNO can be more or less any number, mine start at 50 it's not a DN just a number used to id a list
DNSZ is the size of your DN's eg 2 digit or 3 digit or 4 digit .....
SIZE - is how many entries will there be in the hunt group ( if you build a group that has 5 users ) you can set it to 5 or more, 10 maybe to allow for additional members.
STOR this is where you enter your members DN's STOR 0 is first then you get STOR 01 up to the value of SIZE ....
Just C/R past WRT

Mato' Was'aka