Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

hunt group

Status
Not open for further replies.

is2teli

MIS
Mar 7, 2005
299
US
I need to have a tollfree number setup going to 5 phones and then rolling into Vm. what is the best way to set up?
 
no, ring on first phone and if busy, ring 2nd and so on and after 5th go into vm.
 
You could use a basic hunt group.

To create Hunt Groups you need to use LD18 to store the extensions in the Group Hunt List and LD57, which assigns the Pilot DN to the Group Hunt List.

LD 18
REQ NEW
TYPE GHT
CUST 0
LSNO (Next List Number)
DNSZ (Directory Number Size)
SIZE (Size of list, How many entries)
STOR 00 XXXX (XXXX = Directory Number)
WRT (C/R)
STOR 01 XXXX (XXXX = Directory Number)


Continue with store entries until list completed.

Attaching a Pilot DN (PLDN) to the list number LD 57

REQ CHG
TYPE FFC
CUST 0
CODE PLDN
PLDN (Pilot Directory Number, which must be a unique number on the Meridian)
USE GPHT (Group Hunting)
LSNO List number created in LD 18)
HTYP (RRB=Round Robin, LIN = Linear)
CFWI (NO = Skip Extn if CFW Activated
YES = Terminate on Extn if CFW Activated)
MQUE (ALL = No limit on queued Calls
0 = No calls to be queued
1 = Maximum of 1 call queued)
 
STOR 00 XXXX (XXXX = Directory Number)
WRT (C/R)
STOR 01 XXXX (XXXX = Directory Number)

When I store the DN numbers, will anything else need to be programmed on their phones (the PLDN?)
So I will be pointing the tollfree to the pldn?
 
need a similar setup but need it to ring all same time.....
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top