HP Vectra VE 4 set up password location 1

[chatteris]

Am trying to re-utilise a HP Vectra 4 as a TV Test Card generator and need to disable integrated graphics to instal a TV out card.
I assume that I need to get into Set-up to disable on-board graphics but access is controlled by a password. Can anyone guide me to the location of the password record?
Thanks

 

[franklin97355]

Open up the case and read the notes inside. It will tell you what switch to set to clear the password.

 

[chatteris]

Thanks Franklin,
Found it and cleared it! So far so good but now I'm into Set-up (BIOS)I cannot see an obvious way to disable on-board video adaptor. Any knowledge on this Franklin or anyone out there. A lead to the service manual would help.
Tony

 

[micker377]

http://h20000.www2.hp.com/bizsuppor...TypeId=12454&prodSeriesId=32471&lang=en&cc=us

From HP. Scroll down for Users Manual, etc.