I replaced the fuser assembly and forgot to connect the drive motor when I reinstalled. Of course when I went to print the paper jamed. I have since rechecked all connections and very things is correct. I now get an "Initializing" message which never goes away, thus I do not get to a ready state. I've noticed a few questions posted on the web with type of problem but have not seen a solution. I've tried to reset to factory defaults and to run 2nd secondary tests, no change. Printer has been left powered on for many hours with no change. Upon power up, the fuser assembly goes through a cycle and then then unit just stops with no more sounds with initializing.
Any ideas? Does anyone have a copy of the service manual?
Thanks
Any ideas? Does anyone have a copy of the service manual?
Thanks