cProgPath = sys(2003) &&& the location where the program loaded. assuming that you have set folders that hold the files. assign them to a var. like a sub folder under program folder
cpath = cProgPath + 'txtfil
run type (cpath) > lpt1
run type &cpath > lpt1
Attitude is Everything
cpath = cProgPath + 'txtfil
run type (cpath) > lpt1
run type &cpath > lpt1
i do not wish to hardcode the output to lpt1
i would prefer to use printer name instead.
e.g. my printer name is bill so i would need something like this.
run type (path) > bill (this is not working in dos)
cpath = cProgPath + 'txtfil
run type (cpath) > lpt1
run type &cpath > lpt1
i do not wish to hardcode the output to lpt1
i would prefer to use printer name instead.
e.g. my printer name is bill so i would need something like this.
run type (path) > bill (this is not working in dos)
you have any solution which i can use printer name instead?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.