How to schedule a HST Courtesy Failover

[jimcricket]

I have tried most obvious variations of the spelling to schedule (using Opsman) this event to occur. Other maintenance commands are successful using opsman, BUT I must be spelling this command incorrectly.

Tried HST COURTESY FAILOVER; HST CO FAILOVER; HST CO FA; hsHandoff. and none appear to work. Issueing all of these same commands on the 3300 does work.

When Opsman logs into the 3300 I can see the event occuring in the maintenance window, and I see when the logoff occurs. Its like the spelling of the command is not reccognized, OR maybe it isnt sent by opsman. Opsman is 9.2 Ent man is 6.2....

Thanks JG

 

[Supernova99]

Opsman can only use SX2000 maintainance commands.

HST is a 3300 command

Here is how you can test it

Via the ESM go to maintainance commands and type it in.#
It will be valid and work as expected

Telnet to the controller IP address
Login as system password is sx2000
If you are familiar with the SX2000 then you will see the same desktop.
Press <ESC> then 6 (maintainance)
Type HST <ENTER>
system will reply with unknown command

Share what you know - Learn what you don't