How to program Route 909 for conference

[phonetech1]

Hi!
I am working on a NEAX 2400 IPX, one PIM.
Our station to station conference doesn't work, so I checked the PBX and found that the Route 909 isn't programmed. I don't think that I need any hardware for just a simple three way calling.

One thing that I can't figure out the LEN number for trunks in Route 909.

Can anybody help?
Thanks

 

[AZrichard]

System Data Design Manual shows " Three-Way Calling ".

ATRK:

XX X XX X
Module Unit Group Level
Group

Group and Level numbers for the Digital Conference Trunk are 2-10,2-13,2-16,2-21,2-24,2-27,2-32 and 2-35.

also ASYD System Data 2,Index 1,Bits 0&1.
Index 6,Bits 2&3
Data 3,Index 2. Assign 91Hex
Also ARRC and Arsc.

MBTK- make idle the Digital Conference Trunks

 

[phonetech1]

I figured it out this morning. Haven't worked on a 2400 in almost 20 years. It is coming back.
Thanks for your help.

 

[AZrichard]

welcome back to the NEC world

 

[phonetech1]

A lot of things are still the same. The interface has a lot of new commands, but old commands are still there and it runs on a WinXP PC, versus NEC PC clone with two floppy drives or CP-M 86 computer with 8" drives.
The backplane looks almost the same.

 

[OzzieGeorge]

phonetech1

But don't you miss the PC clone and especially the 8" drives?

The changes may have been minor but the effects have been major. However don't expect it to stay the same forever!

 

[phonetech1]

It's great to have this forum as a support group. I work for the customer now. I take care of many PBX's and I can't go to my vendor every time I have to make a change.

Thanks all of you for your help.