How to place calls over trunks in a remote cabinet?

[adminman3]

We wish to test a PRI in a town that is one of our port networks, but is not in the same state. We want to be able to call from our locale over that remote site's trunks to test to various locations. Is ARS the only way to do this? How about administering a station with a port on the remote switch, then bridging that one to mine so I can call out on it?

What about remote access, using COR to restrict calls to specific trunk groups?

 

[nulabeacon]

How about just using the tac code to access the trunk . Or if you wish to check the ars , using the partiton route table via cor and chaing the cor on a local extension to you . I am sure that you must have ars setup already locally for them to dial using thier own trunks.

 

[AvayaPBXengineer]

verify button ??

 

[LoopbackJack]

To test PRI's I usually put my cell number in the ARS and point it to a route pattern with the new PRI as the only group.