Hello everybody!!!
I never had worked with the Backup Exec and I found some difficulties in how to use this program.
I did the follow
1. Create a job using the backup wizard and start it.
After some minutes the job failed, and it showed a "I/O device error".
2. Changed the tape and start the job again
After some minutes I got another "I/O device error"
I noticed that the errors occurred in different positions, sometimes when it had backuped 2.0gb and sometimes when it had only 400Mb of my all data.
The option 'format' is grey, so I can´t format my tape and the only option that I have is 'erase' and I tried it several times with four different tapes, but when I tried to backup I got the same error again.
I have a Sony tape drive and I have 4mm cartridge DGD125P
And a last question , this program will ask for another tape when it reach the end, because the data to be copied is very large .
Pedro Vasconcellos
I never had worked with the Backup Exec and I found some difficulties in how to use this program.
I did the follow
1. Create a job using the backup wizard and start it.
After some minutes the job failed, and it showed a "I/O device error".
2. Changed the tape and start the job again
After some minutes I got another "I/O device error"
I noticed that the errors occurred in different positions, sometimes when it had backuped 2.0gb and sometimes when it had only 400Mb of my all data.
The option 'format' is grey, so I can´t format my tape and the only option that I have is 'erase' and I tried it several times with four different tapes, but when I tried to backup I got the same error again.
I have a Sony tape drive and I have 4mm cartridge DGD125P
And a last question , this program will ask for another tape when it reach the end, because the data to be copied is very large .
Pedro Vasconcellos