Hi ladies and gentlemen,
I am setting up a new pix firewall and I need to leave ports 5631 and 5632 open to allow for pc anywhere connections. My current configuration on the pix firewall is as follows:
fixup protocol ftp 21
fixup protocol http 80
fixup protocol h323 1720
fixup protocol rsh 514
fixup protocol smtp 25
fixup protocol sqlnet 1521
namespager lines 24
logging on
no logging timestamp
no logging console
no logging monitor
no logging buffered
no logging trap
logging facility 20
logging queue 512
interface ethernet0 auto
interface ethernet1 auto
mtu outside 1500
mtu inside 1500
ip address outside 66.158.63.66 255.255.255.224
ip address inside 192.168.1.254 255.255.255.0
arp timeout 14400
global (outside) 1 66.158.63.67-66.158.63.79
global (outside) 1 66.158.63.80
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
no rip outside passive
no rip outside default
no rip inside passive
no rip inside default
route outside 0.0.0.0 0.0.0.0 66.158.63.65 1
Additionally,I set my one router up like this in a test environment:
interface VLAN1
ip address 192.168.1.251 255.255.255.0
no ip directed-broadcast
ip nat outside
!
ip default-gateway 192.168.1.254
ip nat inside source list 199 interface VLAN1 overloadaccess-list 199 dynamic
Cluster-NAT permit ip any any
Please, if you could, tell me what I need to do to open ports 5631 and 5632
THANKS!!!!!!!!!
I am setting up a new pix firewall and I need to leave ports 5631 and 5632 open to allow for pc anywhere connections. My current configuration on the pix firewall is as follows:
fixup protocol ftp 21
fixup protocol http 80
fixup protocol h323 1720
fixup protocol rsh 514
fixup protocol smtp 25
fixup protocol sqlnet 1521
namespager lines 24
logging on
no logging timestamp
no logging console
no logging monitor
no logging buffered
no logging trap
logging facility 20
logging queue 512
interface ethernet0 auto
interface ethernet1 auto
mtu outside 1500
mtu inside 1500
ip address outside 66.158.63.66 255.255.255.224
ip address inside 192.168.1.254 255.255.255.0
arp timeout 14400
global (outside) 1 66.158.63.67-66.158.63.79
global (outside) 1 66.158.63.80
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
no rip outside passive
no rip outside default
no rip inside passive
no rip inside default
route outside 0.0.0.0 0.0.0.0 66.158.63.65 1
Additionally,I set my one router up like this in a test environment:
interface VLAN1
ip address 192.168.1.251 255.255.255.0
no ip directed-broadcast
ip nat outside
!
ip default-gateway 192.168.1.254
ip nat inside source list 199 interface VLAN1 overloadaccess-list 199 dynamic
Cluster-NAT permit ip any any
Please, if you could, tell me what I need to do to open ports 5631 and 5632
THANKS!!!!!!!!!