I have a CS1000s. Right now our paging only pages to our PA system. How do I set it so the users has the option to page 1) PA only, 2) phone speakers only, or 3) both?
There is not a feature to page over phone speakers. It can be done with a lot of headaches, but even then, only 20 sets at a time (large systems) or 5 at a time (small systems)
two very unique worlds.. bcm/norstar are key systems.. smaller usually.. cs1000, pbx and usually larger. the power supplies required to page over a few 1000 phones would cost more then the switch.. the only tdm interface to page is via a trunk or station port..
I have another question regarding our PA system. The sound quality is very poor. It has a lot of static when the user is paging. What do I need to check to fix this?
You need to determine if the static is coming into the amp, or just going out over the speakers. In other words, is the input quality the problem, or is it the amp, or has someone added incompatible speakers somewhere.
Test this by disconnecting everything installed today, adding one good test speaker, and a known good input source. Then amplify yourself and see how you sound.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.