How to install paper pick assembly phaser 850? 1

[phaser1]

Help? How do I take off the front cover door? How can we take out the broken paper pick assembly? Thanks!!!It's part # 351-1032-00

 

[marty5261]

If you open teh front cover and look on the left side where the cover hinges you will see a hole, using something to push in on that hole will release the pivot hinge and the cover will side off. at that point snap off the paper pick flag from the pick guide assy being careful not to break it. The guide assy snaps in place on each side at teh front, using a small screwdriver pry inwards on each side to release the assy and pull forward to remove. This is a tight fit so be patient but it will come out. Install the new one the same way taking notice of how the back of the assy fits to the metal bottom of the printer. There are plastic pieces on the back of the assy that go over and under the metal bottom. Then just fit the guide assy so the the tabs snap in place and reinstall teh pick flag assy. Again it will be a tight fit but it will go in without having to remove the covers or the pick roller. Hope this helps.

 

[phaser1]

Marty,
This worked perfectly! Thanks so much for your invaluable help! I am indebted to you!

Sue Miller