Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
how to install Cisco router 2500 back to back to Cisco Router 2611.
- Thread starter 003183
- Start date
What you need for the 2611 is a WIC card, specifically, the WIC-1T, here is an eBay link for some
Here is the Cisco link for setting up the routers, back to back.
Let me know if you have any other Questions.
Here is the Cisco link for setting up the routers, back to back.
Let me know if you have any other Questions.
Im guessing you need a AUI Transceiver if you want to go ethernet to ethernet. The older cisco 2500 had AUI connections for ethernet. Make sure they are both 10bT. If they are not you will need an autosensing hub.
you really con't do serial to serial since the 2500 had the old Ciso serial connecters for RS232 or V.35. The new wics have RJ45 connections for the Serial interfaces.
NetEng
you really con't do serial to serial since the 2500 had the old Ciso serial connecters for RS232 or V.35. The new wics have RJ45 connections for the Serial interfaces.
NetEng
robertjo24
MIS
FYI,
The WIC-1T does not have an RJ-45, you are thinking of either the WIC-1DSU-T1 or WIC-1DSU-56K. You can buy a serial DCE to DTE interface cable to go between the 2500 series and the 2611 WIC card.
By the way, was I lied to when they said routing was fun?
The WIC-1T does not have an RJ-45, you are thinking of either the WIC-1DSU-T1 or WIC-1DSU-56K. You can buy a serial DCE to DTE interface cable to go between the 2500 series and the 2611 WIC card.
By the way, was I lied to when they said routing was fun?
robertjo24
MIS
- Status