Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How to install a Digital LIne Card or a Analog Card?
- Thread starter PTALLY
- Start date
As long as you have an open slot you can install it with no problem.
Be sure to place the analog card in a cabinet with a ring generator.
The TN's will not show available till you activate one of the ports on the card.
Remember just because you have a physical port to terminate doesn’t mean you have the software TN’s. You should check what TN’s you have and what you are using.
Use LD 20 if you can or LD 10 and 11.
Steve
Be sure to place the analog card in a cabinet with a ring generator.
The TN's will not show available till you activate one of the ports on the card.
Remember just because you have a physical port to terminate doesn’t mean you have the software TN’s. You should check what TN’s you have and what you are using.
Use LD 20 if you can or LD 10 and 11.
Steve
Shut down the system?!?!?!?!?!?
No you just plug them in a free IPE slot... Really Plug and Play... Not that Microsoft crap...
But you must check your SLT's
LD 22 -> SLT
It will show you how much Dig. and An. sets you can program, have programmed and how you have left to program...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
No you just plug them in a free IPE slot... Really Plug and Play... Not that Microsoft crap...
But you must check your SLT's
LD 22 -> SLT
It will show you how much Dig. and An. sets you can program, have programmed and how you have left to program...
Marc D.
No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.
joelunchpail
Technical User
just make sure you plug them into your network shelf
- Thread starter
- #8
telezapper
Technical User
Try this...
Put your card in an IPE slot then.....
LD 20
Req: new
Type: cardslt L S C (for analog) or
Type: cardmlt L S C (for digital)
Then when you LUVU the card should show up!
Try it .... You'll like it!
Z.....
Put your card in an IPE slot then.....
LD 20
Req: new
Type: cardslt L S C (for analog) or
Type: cardmlt L S C (for digital)
Then when you LUVU the card should show up!
Try it .... You'll like it!
Z.....
- Status
Similar threads
