How to get out of LSP mode

[w33mhz]

I had an issue with the data connection to a remote site, the issue has been resolved but I don't know how to get the 8300 out of LSP mode. I have rebooted the system, but it is still in LSP mode.
I thought that once the link was back up after a period of time the system would detect that and reboot and get out of LSP mode. Apparently I was wrong about that.

 

[DontDeleteMeAgain]

it will if in the CM you have a recovery rule set. the LSP should have come back after you did a reset system 4 in the LSP

 

[w33mhz]

Well that is what I did, but it still states when I log in that it is in LSP mode. There must be something else wrong because when I check the status of a station it shows either out-of-service. I have busy'd out and released the station, but still out of service.
I don't have any alarms or warnings.

Well in the process of writing this they have called stating their phones are working now, still same senerio. I am confused.

 

[DontDeleteMeAgain]

in the CM what do you show when doing status media-ga, does it show as up?

 

[w33mhz]

when I logon to the LSP and to that I show 2 links down under the H.248 Link Summary. But when I go into the main 8700 it shows 2 links up.

 

[DontDeleteMeAgain]

the LSP will not show the current status. what do you show when you do "list sur"?

 

[mgraval]

Telnet to the MG's, login as Root and at the # prompt type configure and then at the next prompt, type RESET MGP, The Media Gateway will reset and connect back to it original CLAN, if the link is ok

 

[w33mhz]

well it everything seems good now. I don't understand what was going on, but I will leave it at that. Thank you for your help.