Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to force commands?? and how to make calls disconnect after a while

Status
Not open for further replies.

ALIGANUNI

Programmer
Jul 26, 2011
9
NO
Good day


Can any one help me:

I'm working in a company using MD110 , the problem that we have some Lims disconnected because of wire cut ,

we can't reach the area in which the cut is.

so now when I try to execute some commands, it gives me Lim(s) blocked.

Is there any way to overcome this problem and force the commands to be executed???

by the way, I'm not an expert in this MML.



Secondly, I'd like to know if there is a way to make calls to external telephones disconnect after a certain time.

Is it possible, if yes how??


thank u all
 
short answers:

point 1 : no, never will
point 2 : depends on your MD110 version and type of extension, please post your CADAP; here

/Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!
 
Hello,

thank you for your reply,

Let me clear something: I wish to force commandS to be executed in the LIMs which still in connection not that out of order.


2- CADAP; the result is:

VERSION=CXP1010101/2/BC12SP11/R8A

 
Aliganuni,

what you want will never work because of the design of the MD110.
If you execute a command it will be passed to all lims, this to ensure data integrity.
In the newer mxone, if all data will be in the LDAP database, this will be possible.

/Daddy

-----------------------------------------------------
What You See Is What You Get
Never underestimate tha powah of tha google!
 
Dear whosrdaddy,


what about the second request?

I posted the CADAP result,please if it's possible with this version let me know how to make these phone calls disconnect auto?
 

You can't make any changes on the MD110 network when a lim is down, you need to get a lim with control cards connected to the group switch, then end the lim in the correct way. You have no option other than to allow the lim to be seen if it is programmed in, so you can't execute any change to do anything at all in step 2 anyway. Get the lim up!

best parnum
 
Although this is bad news for me,I thank u all .


The problem is that these out of order LIMs are in conflict areas in Libya so it's some how impossible to recover them ....


 
As parnum wrote, if you have some spare LIM you can connect it to the GS at the position of the broken LIM and get it up. Then you can execute the commands.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top