How to do "Forced Trunk Release" in NEC SV8100

[blasteal]

Hi All,

We are currently developing an application for call management . We have an included feature that will kill a call based on the applied rules. For example, a call from certain number is to be killed when this call is diverted to such number. And in this scenario, the call is connected trunk to trunk, hence, TAPI lineDrop function could not be used for this. In other PABX(e.g. Samsung), there is a programming command (forced trunk release) that is used to kill a call thru a trunk. Is there any similar function in SV8100?

Thanks in advanced.

 

[belevedere]

Set up an access code in 11-10-26, Allow forced trunk disconnect in COS 20-07-11, Enable 21-01-18 (default is already allowed).
To use it, dial #9 + trunk number + service code.

 

[blasteal]

Can we do this command via PCPro?

 

[belevedere]

I do not know of a way to do this other than via a dialed code from a phone.

 

[blasteal]

Thanks for providing me this insight. How about doing this command by IP Softphone? Sorry if this is a silly query for you because you mentioned that you don't know of a way to do this other than via a dialed code from a phone. But you mentioned "via dialed code from a phone", then, can we do this via IP Softphone?

 

[belevedere]

Yes, it's just an access code that can be dialed from any type of telephone, hard or soft.

 

[blasteal]

Thanks a lot. Your information is very much appreciated.