How to display stations in busy condition on NEC 2400 IMX 1

[tdewar]

We are using MAT R11 2.07 on a NEC 2400 IMX. I found an old manual for a NEC 200 ICS that had a DMBS (Display of Make Busy Station) command listed, but or system does not recognize that command. Does anyone know of a similar command that would work on our system?
Thanks!
Tom

 

[belevedere]

Try DCON or in the older MAT, DCONX, or MBST 1 = busy. These are individual station commands.

 

[tdewar]

I was actually looking for a command that displays the MBST status of all stations if there is one. It sounded like DMBS would have done that had it worked.
If I use MBST I can see the status of an individual station.
Thanks!

 

[3racefan3]

SPTS might work for you.

 

[OzzieGeorge]

Don't have a manual to hand but the list up commands usually start with "L" so check the manual for commands that start that way! See if for example lbst or lmbs exit for example. I used to find that approach useful.