How to Disable Transfer Recall on IPX

[ambroome]

Hello, I'm looking to disable the transfer recall feature on an NEC IPX. I specifically want to be able to transfer to a station blind without the PBX knowing better and performing a recall if the target station is invalid or nor programmed. I see where people talk about the timer for this, so do I just set the timer to 0? Thanks!

 

[belevedere]

In most cases the station is forwarded to VM. The call forward no answer timer is set a little less than the transfer recall timer so it does not conflict. If the station is not forwarded it should recall.

 

[ambroome]

So from what I'm reading, this all makes sense. However, I'm not using a VM system. Is there a way I can disable the recall feature?

 

[belevedere]

Try ASFC SFI 104 set to 0. Processing when the transferred station does not answer for a predetermined period of time in Blind Transfer
0 = Transferred station continuously rings Note 2 Note 3
1 = The transferred call is forwarded when Call Forwarding-Don’t Answer is assigned at the transferred station and no-answer timer expires.
Note 2: The following system data setting is necessary. ASYD, SYS1, INDEX69, bit 0=1 (according to the settings
of ASFC SFI 104)
Note 3: This data is valid when SFI 180=1 is set to the counter station.