Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to create Call Coverage Path that continues working in a Round-Robin / Loop fashion? 1

Status
Not open for further replies.

avi777

Technical User
Jul 22, 2014
29
US
Regarding thread690-1670813, after you enable Station Hunt Before Coverage in system-parameter coverage-forwarding,
How do you configure the stations to hunt in a chain?

I have three stations in a coverage path, and the call always stays ringing on the last station.
If I add the first number the chain at the end, the call will route, but stays stuck ringing on the first station.

Thanks.
 
You might need a hunt group
add hunt-group next Page 3 of 60
HUNT GROUP
Group Number: 1 Group Extension: Group Type: ucd-mia
Member Range Allowed: 1 - 1500 Administered Members (min/max): 0 /0
Total Administered Members: 0
GROUP MEMBER ASSIGNMENTS
Ext Name(19 characters) Ext Name(19 characters)
1: 14:
2: 15:
3: 16:
4: 17:
5: 18:
6: 19:
7: 20:
8: 21:
9: 22:
10: 23:
11: 24:
12: 25:
13: 26:

At End of Member List
A coverage answer group will work imho better.
add coverage answer-group next Page 1 of 9
COVERAGE ANSWER GROUP

Group Number: 8
Group Name: COVERAGE GROUP

GROUP MEMBER ASSIGNMENTS

Extension Name
1:
2:
3:
4:
5:
6:
7:
8:
All stations ring until answered won't round robin.
Hope this makes sense
ED

1a2 to ip I seen it all
 
On your coverage path point it to the same hunt group in all the coverage option paths , make the hunt group type circ , and in hunt group make its coverage path you have created.Give the stations the same coverage that exsists in the hunt group.

ACSS (UC/SBCE/SM/SME)

Not that they mean a thing anymore , get a brain dump pass the test crash the system.
 
Thanks for your inputs.

I created the coverage path pointing to the hunt group in each coverage point (all six), and added that coverage path to
the hunt group set up as circular type, and in each of the stations. It works well up to the sixth point, then returns
to the first number in the group and camps there ringing. So I created an extended coverage path so that when it rings
the first six points on the first coverage path, then it should jump to the next six points in the second coverage path.
Only that it doesn't. It stays on that first extension after the initial six point pass.

I configured both coverage paths to route to the NEXT PATH NUMBER of each other, i.e., 632 to 633, and 633 to 632.
Can't get the loop to continue.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top