How to configure NTP on Catalyst 6000 MSFC

[freddick]

Looking for the steps to configure NTP on the MSFC portion of a Catalyst 6000.

I found info on Cisco's site for HA dual MSFCs, but I only have a single MSFC.

Thanks in advance!

 

[rainman]

Here is the configuration I use on a 6509 w/ SUP2 and MSFC2:

Layer 3 MSFC2 config (IOS):

config term
!
ntp server 1.2.3.4
!
end


Layer 2 SUP2 config (CatOS):

#ntp
set ntp client enable
set ntp server 1.2.3.4



Hope this helps!


-Rainman

 

[freddick]

Thanks for the reply. That is pretty much what I found. The switch portion could use the set commands...and ntp would work as you have indicated after entering those two commands.

The msfc will not work with just the server command. It seems to need something equivalent to the 'set enable'.

So I am still searching for how to get the msfc to update.

Thank you, Fred