how to configure and install make package?

[mxstein]

I've dowloaded make-3.80-sol9-sparc-local.gz from sunfreeware. After dowloading i gunzip'd it and did a pkgadd -d on the make package. From reading the INSTALL file I next tried to configure it by doing ./configure but I get the error ./configure not found. I've tried running ./configure from every directory that has anything about make in it, but get the same error. If someone could tell me how to configure and finish intalling make-3.80 I would appreciate it. Thanks.

 

[bfitzmai]

If you installed this package, you do not have to compile or configure anything. The make command has been placed in /usr/local/bin. There is a source code download called make-3.80.tar.gz

 

[gkout]

# cd /dir_where_the_package_is
If you downloaded the package from sunfreeware you must run pkgadd as follows:
# pkgadd -d make-3.80-sol9-sparc-local