Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to change analong line to 800 and local only? 1

Status
Not open for further replies.

bhorocks

IS-IT--Management
Feb 20, 2007
68
US
I just posted earlier but i dont see it in the forums so reposting.

I'm trying to search for a thread on changing a number to only access 800 and local calls only.

below is a build of the current phone. what od i need to cahgne in order to get this to work?

Switch is an 81c

thanks!

DES FAX
TN 004 0 06 12
TYPE 500
CDEN 4D
CUST 0
WRLS NO
DN 8266 0 MARP
AST NO
IAPG 0
HUNT
TGAR 1
LDN NO
NCOS 4
SGRP 0
RNPG 0
XLST
SCI 0
CLS CTD DTN FBD XFD WTA THFD FND HTD ONS
LPR XRD CWD SWD MWD RMMD SMWD LPD XHD SLKD CCSD LND TVD
CFTD SFD MRD C6D CNID CLBD AUTU
ICDD CDMD EHTD MCTD
GPUD DPUD CFXD ARHD OVDD AGTD CLTD LDTD ASCD
MBXD CPFA CPTA DDGA NAMA MIND
MCRD SHL ABDD CFHD
USRD BNRD OCBD RTDD RBDD RBHD FAXD PGND FTTC
PLEV 02
AACS NO
MLWU_LANG 0
DATE 17 JUL 2002
 
If I understand you correctly, you want this set to only be able to dial local & 800 numbers.

First attempt to change NCOS to 1.

That should take care of it, however this could be a non standard install, in that case there would be a lot more information required.
 
Yea it would all depend on how your BARS info is set up in LD 90 and LD 86

 
seting the ncos to 1 did the trick thanks alot!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top