How should i activate a phone after i have registered on Meridian 1 , with LD 10 commands ?

[interuser]

How should i activate a phone after i have registered on Meridian 1 , with LD 10 commands ?
How can i activate Analog Sets after i have registered like this in the System .

LD 10
REQ : NEW
TYPE : 500
TN 99
DN 2506
DES M80009
REQ : END
After i've done this , how can i activate the phone ?

Thank you .

 

[Johnthephoneguy]

Plug it in

JohnThePhoneGuy

"If I can't fix it, it's not broke!

 

[yyrkroon]

That phone is not going to work - that's not a valid TN.

If this is an OPT11C or CS1000 CAB, the TN format is C U (card unit)
If this is larger than the CAB then the TN format is L S C U (loop shelf card unit)

 

[interuser]

How can i find TN number in OPT 11 C that's the system i'm using right now ?

 

[yyrkroon]

LD 20
REQ LUVU
TYPE 500

Press the Enter key for everything else and wait for the print - what's printed is all your available 500 TN. Do the same for digital by inputting 2000 at the TYPE prompt.

 

[interuser]

One more question , for analog phones TYPE should be always 500 right ?
What about digital phones ?

 

[Firebird Scrambler]

500 is for analogue phones and it depends on the digital phone type as there are many different versions.

The link below will show a few examples.




Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support

http://www.linkedin.com/in/davidbromley

 

[interuser]

And what about DES , what should i write ? For digital and analog phones ?

 

[Firebird Scrambler]

In "DES", you can enter up to 6 digits or Characters of your choice. It doesn't affect the operation of the phone. Usually we tend to add in the Phone type as it's for reference only.


Firebird Scrambler
Nortel Meridian 1 / Succession and BCM / Norstar Programmer in the UK
Advance knowledge on BCM support

http://www.linkedin.com/in/davidbromley