How do you set a BCM with (2) 4x16 to see loops 2

[parkgroup]

I had heard that it sees T1 on default

 

[cook1082]

Depends what version if using Elament manager go to Resorces/ Telephony resorces and the Bus it's on cange the card to the 4x16 combo.

 

[biv343]

Set the first card to bus 2 and the second card to bus 4, as each card uses two DS 30 loops. Dip switch settings are in the installation and maintenance doc which is on the hard drive of the system.

 

[parkgroup]

I have been through several settings

Some say leave 1st (MBM)4x16 all on(don't know if first is top or bottom...I think Nortel counted from the left in the MICS)I chose bottom. Top 4x16 I have tried 3, 4, 5, 6. I look in resources and have 4 modules in 2. I tried the reverse too.

Have eleven extesion up. Started out with one set and I can see 8 ingoing lines that I have plugged in.

Some of twenty sets show up 254 to 264. The rest seem to be live but no extension on F*0 intercom. Other just flash forever.

Bus 01, 3,4,5,6,7 are Stn Modules Bus 2 is only trunk module Bus 8 is data module

 

[parkgroup]

I have the documents...interpretation is vague

This is BCM200 V 3.7

 

[parkgroup]

I have top slot 4x16 MBM set On\On\On\On\On\On
The bottom slot 4x16 MBM set On\On\On\On\Off\On

Now I get 151-154 and 211-214 lines

one station set works the other doesn't opposite to what I had earlier.

Trunk Modudes are on Buses 02 & 04

Before I could get any extensions on 25pr cable attached to the top 4x16 now I cannot get any extensions on the other cable (bottom 4x16)Any advice as how to get the station sets active on both 4x16s

 

[parkgroup]

Started workin eventually