Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
How do you reset the Administrator password on IPO 500 V1
- Thread starter Gus63
- Start date
- Thread starter
- #2
I have tried Hyper terminal
AT
Got OK response
entered
AT-X2
Got ERROR
entered
AT-X3
Got ERROR
I just want to wipe out the old config but the old IT guy does not work there and he changed the default password.
How do I again access to the IPO?
AT
Got OK response
entered
AT-X2
Got ERROR
entered
AT-X3
Got ERROR
I just want to wipe out the old config but the old IT guy does not work there and he changed the default password.
How do I again access to the IPO?
- Thread starter
- #3
Gus, AT-X is not needed at all!!!
But if you want to do this with the DTE port then do it this way:
AT <enter>
at-debug <enter>
erasenvconfig <enter>
eraseconfig <enter>
reboot <enter>
This should do the trick
But it is easier with Manager
When you do not have the login credentials then you need the DTE port again.
Reboot the IPO and type:
AT <enter>
AT-SECURITYRESETALL <enter>
Enter the shown MAC address and you are done.
BAZINGA!
I'm not insane, my mother had me tested!
But if you want to do this with the DTE port then do it this way:
AT <enter>
at-debug <enter>
erasenvconfig <enter>
eraseconfig <enter>
reboot <enter>
This should do the trick
But it is easier with Manager
When you do not have the login credentials then you need the DTE port again.
Reboot the IPO and type:
AT <enter>
AT-SECURITYRESETALL <enter>
Enter the shown MAC address and you are done.
BAZINGA!
I'm not insane, my mother had me tested!
DO NOT Erase config except as an absolute last resort.
AT-SECURITYRESETALL only works from V3.2 upwards
for earlier systems use one of the following
1) use Revelation on a backup copy of the config file
2) Use IPOpass (requires a network connection to the system)
3) get a reduced cfg from the system then use Revaluation.
form the command line type
(this is the process that IPOpass uses).
A Maintenance contract is essential, not a Luxury.
Do things on the cheap & it will cost you dear
AT-SECURITYRESETALL only works from V3.2 upwards
for earlier systems use one of the following
1) use Revelation on a backup copy of the config file
2) Use IPOpass (requires a network connection to the system)
3) get a reduced cfg from the system then use Revaluation.
form the command line type
Code:
tftp -i <ip address of system> GET config/shared.A Maintenance contract is essential, not a Luxury.
Do things on the cheap & it will cost you dear
- Status
Similar threads
- Locked
- Question
