How do I trace an incoming call on E1 R2 trunk

[AntBan]

Hello,
My Ericcsson is acting as a tandem switch between an ISDN site and an E1 R2 site.

bldgAPBX----E1 R2----MD110---E1 ISDN----bldgBPBX

We have successfully set up to make calls from ISDN side to E1 R2 side, but I am not able to place calls from E1 R2 side to ISDn side.

I am not sure if the E1 R2 originating side is sending the correct called destination digits. The PBX at bldgA states it has sent the correct digits, but the MD110 does not proceed with the call but doesn't teardown the call immediately either. Which makes me think that it is waiting for the complete number to route.

Can someone tell me how to trace an incoming call on the MD110 for a E1 R2 trunk?

Thanks

 

[amalpbx12]

try CTCOP:BPOS=XXX-X-XX-XX;


XXX=LIM

X=MAGAZINE

XX=POSTION



If u have any problem,question about MD110,just call +218913645167,available 24/7

 

[TheCurious]

For R2 tracing take a look at: thread806-1034687


The Curious