How do I delete a DTI Loop from a CS1000E - err SCH5589

[fgallard]

I have removed the members in LD 14, I also removed the RDB in ld 16, there is no D channel associated to ths TIE line but I cannot remove it, see errors below when I type the X UN LD 17.

Thanks

REQ chg
TYPE cequ
MPED
TERM
REMO
TERD
REMD
TERQ
REMQ
XCT
MGTDS
MGCONF
MFSD
DLOP x
SCH2022
DLOP x162

SCH5589
DLOP

 

[luckymoses]

Go to LD96 and DIS TMDI.

 

[fgallard]

Please pardon my ignorance, how is the TMDI disabling comand linked to the unability to remove a DTI loop?

Could you also let me know if the command should be

LD 96

REQ DIS TMDI <ENTER>

Thanks

 

[fgallard]

This is what I have under CEQU what's the TMDI number for loop 162?

DLOP NUM DCH FRM TMDI LCMT YALM T1TE TRSH MG_CARD
TRK 161 24 ESF YES B8S FDL 0 00 000 0 02
162 24 ESF YES B8S FDL 0 00 000 0 03
PRI 163 23 ESF YES B8S FDL 0 00 000 1 02
164 23 ESF YES B8S FDL 0 00 004 0 04
166 23 ESF YES B8S FDL 0 00 008 0 01
167 23 ESF YES B8S FDL 0 00 008 1 01
168 23 ESF YES B8S FDL 0 00 012 0 01
169 23 ESF YES B8S FDL 0 00 000 1 03
170 23 ESF YES B8S FDL 0 00 000 0 01
171 23 ESF YES B8S FDL 0 00 000 1 01

 

[bhassell2000]

do a stat tmdi in ld 96

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[PERRYPJ]

LD 96
dis tdmi 0 0 3

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[fgallard]

Thank you it is all done, I also documented the steps in case someone else needs the information simplified. But I am not sure how to remove a clock or to move a clock if there is one associated with the span?


Steps to remove a Loop TMDI span on a CS1000E Rls 5.x

1) Print the loop information on the following loads
LD 60 stat
LD 21 LTM
LD 20 TN (Trunks)
LD 21 PRT RDB #
LD 22 CEQU
2) Steps to out the loop

LD 60 DISL #
LD 14 OUT 24 TNS
LD 16 OUT RDB
LD 96 DIS TMDI (From CEQU info)
LD 17 DIS DLOOP #

If there is a D Channel involved the D Channel most be deleted in LD 17 CHG ADAN

If there is a clock controller the clock most be moved to a different span.

 

[PERRYPJ]

To change a clock source switch it to the Secondary then remove the clock card from the TMDI and insert it on the new Primary clock source TMDI, Then you just go to LD 73 and change it in software and switch back to the Primary

OLD ROLMEN WORKING ON NORTELS AND AVAYA