How do I change Auto Answer Ring Count if possible?

[SeanCPDX]

System: MICS 0X32 w/ MICS 5.0 software.

I have a couple analog lines setup with "Ans Mode: Auto" and DISA set to No. These lines are connected to a VoIP gateway on each end of a Point To Point T1 Circuit.

I would like to change the ring count in which the system waits to answer a trunk, and present the caller with a dialtone. This will speed up the amount of time needed to connect a call between two offices(less rings).

Is there a way to change the ring count in which the system waits before answering a call with a system dialtone in auto answer mode?

 

[hawks]

Can you build an Answer DN and assign the trunks to it. Then when someone hits those trunks they should receive system dial tone from the far system.

 

[SeanCPDX]

See Thread :VoIP Scenario, Need to change auto answer ring count on trunk cards. for clearification.