How can I found out what trunk is in a gateway? 1

[OCsurfer]

I did a List configuration media-gateway (number of gateway) is 20 and I do see the cards that are in this particular gateway. There are 3 DS1 MM with board numbers but I need to know which T1 trunks these represents when I do a List trunks.
What is the next CM command to do this?
CM 6.0

 

[kyle555]

list sig should show you d channels on that gateway as a start

 

[joe2938]

test board xxx will tell you as well

 

[Tolson]

use the command disp port XXvY01 where XX = the gateway number, 20 in your case, "v" is a constant, Y=board number and 01 is the first port on that card. The system will return an identification like 1/01 which says this is trunk group 1 member number 1.

 

[dialtonebone]

After you've "list conf media-g xxx" you can start checking the port numbers and the assigned TG/member numbers with the "display port" command.

 

[keops7]

Hi,

Just run "list conf media 20" and you will see with boards have connected and which ports are used.

After that, just "display port 20vBPP" where B is the Board number and PP is the port number.

You will find it out easily in that way.