Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hounting group 1
- Thread starter Faramir56
- Start date
-
1
- #2
There was a post about this some time back...this is what i picked up , quite useful:
A basic group can be set up using this command:
GHGRI:GRP=xxxx,TRAF=15,QUE=yy,SERV=10000,SEL=110000;
xxxx is the number you wish to use, this must be a free number in the extension range.
yy is the queue length, if all agents are busy how many callers would you like to have waiting.
Then to assign members you use the command:
GHGMI:GRP=xxxx,DIR=zzzz;
where xxxx is the group pilot number and zzzz is the member number, which must be an existing extension.
”Beginning is half done.”
A basic group can be set up using this command:
GHGRI:GRP=xxxx,TRAF=15,QUE=yy,SERV=10000,SEL=110000;
xxxx is the number you wish to use, this must be a free number in the extension range.
yy is the queue length, if all agents are busy how many callers would you like to have waiting.
Then to assign members you use the command:
GHGMI:GRP=xxxx,DIR=zzzz;
where xxxx is the group pilot number and zzzz is the member number, which must be an existing extension.
”Beginning is half done.”
- Status