Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

hot line over tie

Status
Not open for further replies.

999said999

Technical User
May 19, 2008
9
OM
Hi everyone,
we have two option 11c connected together via E1 PRI (TIE).
we need to program a two-way hotline between the two sites.
we where successful to program a two way hotline within the same site extensions, however when we used the same logic for the TIE didnot work:
KEY 0 HOT D 4 (SITE B EXT) (SITE A EXT)

please advice

 
your dialing four digits across the tie..

hot d 4 1234 will dial 4 digits, if you dial 1234 does it ring the far end.. test it one direction

KEY 0 HOT D 4 (SITE B EXT) (SITE A EXT) add a h,r,n or v for hot, ringing,nonringing or voice .. you can add clid or d for default/ optioal

john poole
bellsouth business
columbia,sc
 
Yes, one way is working.
site a can ring site b 1234 ext.
but we need a way to let 1234 also dail site a ext ??
 
it's the same key on the far end, just reverse the ext numbers..

john poole
bellsouth business
columbia,sc
 
site A:
m3902
key 0 hot d 4 (site B)

so there is no extension to be reversed in site A

because KEY 0 HOT D 4 (SITE a EXT1) (SITE A EXT2)
is valid only within the same site only

but when tried KEY 0 HOT D 4 (SITE B EXT) (SITE A EXT)
for the tie didnot work
 
Hi johnpoole,
it worked. my bad, i reversed the order of the extensions !!
so it should be key 0 hot d 4 (destination ext) (local ext)
thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top