advfilmssaul
IS-IT--Management
I am trying to set up a little CCNA lab at home using two 2501's. I would like to hook up a cable between the serial interfaces on both routers.
I assume that Cisco sells a cable that would work but I am sure that it is expensive.
Are there any workarounds or less expensive cables or do you need additional equipment (such as CSU/DSU) to make this work?
I assume that Cisco sells a cable that would work but I am sure that it is expensive.
Are there any workarounds or less expensive cables or do you need additional equipment (such as CSU/DSU) to make this work?