oraytektips
Programmer
Hi,
Is there a way to display the HMC name from the command line of the LPAR.
Thanks
Is there a way to display the HMC name from the command line of the LPAR.
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HMC name from LPAR
- Thread starter oraytektips
- Start date
- Status
You could try and find out which socket communications are active from HMC agents on the LPAR, and from the remote IP address, work your way back to the hmc name.
You could also make an entry in /etc/hosts for "myhmc", but granted, that's an extra configuration step. And what if you have two HMCs in a hi-availability config?
HTH,
p5wizard
You could also make an entry in /etc/hosts for "myhmc", but granted, that's an extra configuration step. And what if you have two HMCs in a hi-availability config?
HTH,
p5wizard
- Thread starter
- #5
oraytektips
Programmer
#lssrc IBM.ManagementServer
gave me an ip address and
#nslookup ip
gave me the HMC name
Thank you all
gave me an ip address and
#nslookup ip
gave me the HMC name
Thank you all
- Status