HIPATH4000 DIUN2

[nimrod2016]

i did change bcsu DIUN2 to DIUT2 to replace and check new card i did change funsu command as it appeared and warned me.
now i changed the config back to diun2 the circuit is working fine but the green lamp is not lighting does anyone come across this kind of problem. pl help. my system is v3.8.4

 

[sbcsu]

Why the change from one card to another and then back again ??

DIS-BCSU;
Is the card in service/showing READY ?

DIS-SDSU:ALL,,PEN,PER3,1,x,x;
See status of ISDN circuits on the Card - are they showing READY ?

 

[nimrod2016]

why ?? because preparing a harddisk for remote site and did not have diun2.

all ok sdsu ready card ready only the green lamp is not coming up to show visible indication.

 

[sbcsu]

The LED could be faulty ?
Does it light when you insert the card ?
If all else is working ok then I would not worry about an LED indicator

 

[nimrod2016]

ok thankyou sbcsu i will leave it like that.