Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HiPath Assistant Frozen
- Thread starter ner1116
- Start date
Open ComWin/Expert Access and login to the HiPath
STA-UW7;
put in your username and password that you normally use on the assistant.
(If it asks you what type of terminal then type in ANSI)
If it says you have mail then just ignore that.
Type in
init6
the Unixware will reload.
If you want to see it load up or if you want to log on via the serial line on the bottom processor there is a male 9 way 'D' type connector marked 'service'
Plug that into your laptop.
Open Hyperterminal or any other terminal session
Open it at 38400-8-N-1
You can also log on from there and do the 'init6' as above
Or when it is loading up you can see if there is a problem.
STA-UW7;
put in your username and password that you normally use on the assistant.
(If it asks you what type of terminal then type in ANSI)
If it says you have mail then just ignore that.
Type in
init6
the Unixware will reload.
If you want to see it load up or if you want to log on via the serial line on the bottom processor there is a male 9 way 'D' type connector marked 'service'
Plug that into your laptop.
Open Hyperterminal or any other terminal session
Open it at 38400-8-N-1
You can also log on from there and do the 'init6' as above
Or when it is loading up you can see if there is a problem.
- Thread starter
- #3
- Status