Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hipath 4000 V6:

Status
Not open for further replies.

seif1979

IS-IT--Management
Nov 22, 2014
14
TN
Good evenning,

i have a problem with Hipath 4000 V6; digital stations not yet works and there is no voltage on the boards outgoing.

what is the problem in your opinion; please help me.

thanks

Regards
 
please help me it's urgent.

Please telle me which procedure I follow.
 
Hi,
Not enough information.

Possible power supply fault.

Is it a 19 inch rack system ?

Check the power supplies / Re seat the cards

 
Is the backplane actually hooked to that thingamajig that turns it into an Amphenol connector? I know it has a name. Maybe if that cable is off or not seated or however that thing connects to the backplane that could be the problem? I know V7 has those adapter things - don't know for sure if V6 has them too because we skipped over that version.

Just me speculating. That would be secondary to the power supply, of course, but I would assume if it was a power supply there might be other issues....
 
I found in the older systems with the external power box (Weir power supplies) that you could have Optisets programmed up and look OK in the DIS-SDSU but would not work until you turned on all the switches in the power box.

As donb01 says the Stecker plugs on the backplane have to be pulled towards you to check to see if they have clicked home properly
 
it's an ltu shelf connected with an uacd with bulk and talk connectors; and both are connected.

but i dont think it's a power problem because i have green led in the card; and cards status are ready.

so in your opinion what's the problem.
 
OK - its the bulk ones - I had it before - Honestly !!
Turn on ALL the bulk switches and try the optisets/optipoints again...

 
Hi,
Noise on the line means that the line is at least connected.
He has no voltage on the circuits...

Turn on all the bulk and talk switches on the power unit should resolve that.

If you have noise then on circuits that is an indicator of a bad connection either on the ISDN or locally on extensions.
 
Dear freinds,

It's ok openstage start successfully, but i would like to know how configure openstage 80T

Thanks.
 
My Openstage 80T's are all configures as an Openstage 60 in the TDM setup. They don't have an option for the 80, but the 60 is the same.

--TIger
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top