Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Hipath 4000 - deactivate CLIP
- Thread starter kebab4000
- Start date
- Thread starter
- #3
WARNING: I grabbed this out of the manual - use at your own risk!
Try this:
CHA-FEASU
TYPE=D
CM=CLIP
This looks to deactivate CLIP system wide. If that turns out to be a bad thing you should be able to do the same command and say TYPE=A.
It doesn't look like there is any way to disable it on a station by station basis, but AMO SCREN and ZAND are also referenced in the manual when searching for CLIP. This is a Hicom 4000 1.0 manual from 2005, so changes may have occurred.
Try this:
CHA-FEASU
TYPE=D
CM=CLIP
This looks to deactivate CLIP system wide. If that turns out to be a bad thing you should be able to do the same command and say TYPE=A.
It doesn't look like there is any way to disable it on a station by station basis, but AMO SCREN and ZAND are also referenced in the manual when searching for CLIP. This is a Hicom 4000 1.0 manual from 2005, so changes may have occurred.
- Status