Wendelspanswick
Programmer
We currently maintain a Hicom Office E OfficeExtended 150H V1.0 which has a CBMOD CPU which has the V24 port on the front. I use Hipath Manager E 3000 via a USB to Serial and a 25 pin cable to communicate with it with no problems.
We have bought another Hicom as spares but I am struggling to connect to it. This one has 2 V24 ports on the back of the cabinet (V24/1 and V24/2), I'm using the same software and cable but its just not seeing it as online although it powers up OK (the 7 segment LED does what its supposed to).
The spares unit has a CBIB main board which I can't find any reference to online, I guess the spares unit is a newer release.
The pain is we don't have any spare back plane cables to connect an Optiset to it to look at the programming via the phone.
Any ideas on hope to go forward with this?
Have you tried turning it off then on again!
We have bought another Hicom as spares but I am struggling to connect to it. This one has 2 V24 ports on the back of the cabinet (V24/1 and V24/2), I'm using the same software and cable but its just not seeing it as online although it powers up OK (the 7 segment LED does what its supposed to).
The spares unit has a CBIB main board which I can't find any reference to online, I guess the spares unit is a newer release.
The pain is we don't have any spare back plane cables to connect an Optiset to it to look at the programming via the phone.
Any ideas on hope to go forward with this?
Have you tried turning it off then on again!