Hicom 300 dis-vegas status=unknow

[pcravo]

Hello,
When I make a DIS-VEGAS I've the status in the SWU = Unknow instead Finish or free.
I already made a sta-del:"as:vegas/datei" but I can't solve this.

In result I can't make a REGEN, I've the message that the SWU is in the implausible state and doesn't exist.

If someone have a trick I aprecciate well,

Thanks

 

[sbcsu]

Hi,
The only way I know to fix it is to REGEN everything of importance manually.
Make up a new hard drive and install.
If you have an old Regen file you can see the AMO sequences that need to be Regenerated.

You could try a processor switch over if it is a duplex but it would be best to have another drive prepared and ready just in case of any unforeseen eventuality

Would it be a V4 ?

 

[pcravo]

This is a old version H300E V3.5.

 

[sbcsu]

Well it means that you would need to create a SCSI disk.
You could reload it from the disk or if there is an MO disk there ?
Take the MO and boot it somewhere else
Then get a Regen out of that.