Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hicom 150 Hardware Expansion Map

Status
Not open for further replies.

Mojomomo

Technical User
Apr 9, 2004
7
US
Hi, I have a Hicom 150 and I'm administering it primarily through the Assistant E software. Under the "System Status" category is a section called "Cards" and then under that is a graphical depiction of the hardware (cards) that are inserted into the system. Assistant E calls this the "System Expansion Hardware" section.

My problem is that the image is wrong. It shows that I have cards installed in slots where there are no cards (though possibly there may have been at one time, I'm not sure). The software won't let me remove them and I can't figure out why it's showing such a thing anyway.

Does anyone know how I can fix it? I see an option in the manual that talks about using a System Administration Access Code (the code is *95 + 62659321) to "Reset the boards and port assignments stored in the system". But that's all it says about it, so I'm not really sure what it would do. I'm worried if I do that I will lose all system data.

Any ideas or thoughts would be appreciated! Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top