Hi, Howto for setup Hipath 4000 v6

[RonnieDio1]

Hi,
Howto for setup Hipath 4000 v6, usb iso image.

Thanks!!!

 

[adibv]

Depending of release sw. ver. of V6 you may choose one of 2 variants below:

Prerequisites: 8GB Stick.
1) Insert the USB Stick and wait that Windows detects it
2) Start the HPUSBDisk.exe program and
- select under Device the USB Stick drive
- select File System FAT32
- optionally you can select Quick Format
- make sure "Create a DOS startup disk" is unselected
- press Start
- wait that the tool displays a message box saying that the format was successful and informing about new available disk space
- press OK
- press Close
3) Use the "Safely Remove Hardware" to remove the stick
4) Remove the stick after you get the message that you can remove it safely
5) Insert back the USB Stick and wait that Windows detects it
6) Start the unetbootin-win-549.exe program and
- select the DiskImage option
- leave the "ISO" option selected
- use the "..." button to browse and select the HiPath 4000 Installation ISO
- under "Type" leave selected the "USB Drive" option
- under "Drive" make sure you select the USB Stick Drive
- press OK
- wait until the process is finished
- press Exit
7) Use the "Safely Remove Hardware" to remove the stick
8) Remove the stick after you get the message that you can remove it safely
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,

Prerequisites: 8GB Stick or bigger, but not bigger than 32GB.
1) Insert the USB Stick and use the standard Windows Formatting User Interface/Tools to
format it.
IMPORTANT: make sure to select “FAT32” as Filesystem. If the USB Stick is already formatted with NTFS please reformat with FAT32.
2) Start the unetbootin-windows-625.exe program and
- select the DiskImage option
- leave the "ISO" option selected
- use the "..." button to browse and select the 4K Installation ISO
- under "Type" leave selected the "USB Drive" option
- under "Drive" make sure you select the USB Stick Drive
- press OK
- wait until the process is finished
- press Exit
7) Use the "Safely Remove Hardware" to remove the stick
8) Remove the stick after you get the message that you can remove it safely

 

[RonnieDio1]

Hi,
After install in Hipath, Portal error, boot.clock service error, not access browser.

 

[adibv]

You can see all services on:
/etc/init.d # ls
and check status for boot.clock service:
# service <.....> status
And try to restart it via:
# service <.....> stop
# service <.....> start
or
# service <.....> restart

You must be logged as root/engr.

 

[RonnieDio1]

IP 192.168.0.3 no ping and no access portal...

 

[adibv]

From where there is no ping and no access Portal.
From remote access, Atlantic IP ?
Is there any firewall in the middle ?
What about local connection to PABX ?

 

[RonnieDio1]

Hi
HD number 2 is bad, if replace new HD in 2º pos. without Suse linux.
It will copy from the HD 1 system, HD 3 left out for now.
Yes, I already have access to the system.

 

[RonnieDio1]

Thanks !!!