I have the below attached alarms on my dual processor isdx which was upgraded to a Hipath Dx Version 11.
Processor A is working ,can get dial tone and do some listings ,not history file,but cannot do some moves and changes.
Processor B has a fault indicated by DLP2 red meaning software error present, DLP13 and DLP14 red indicating Shelf Interface and Shelf Interface DCC down or offline.
Processor cards are System Cards 1HAC50159AAA and IMC card 1HAC50153AAH.
The Herma file is missing if you go into SMI mode and I have no back up copies.
I changed the Shelf Interface CPUB SI 0302 and processor B is still showing alarms.
All power supplies look ok.
How can I get the Herma file back in its directory.I am worried if I do a cold reboot the exchange might not come up.
Regards
alfasud
Processor A is working ,can get dial tone and do some listings ,not history file,but cannot do some moves and changes.
Processor B has a fault indicated by DLP2 red meaning software error present, DLP13 and DLP14 red indicating Shelf Interface and Shelf Interface DCC down or offline.
Processor cards are System Cards 1HAC50159AAA and IMC card 1HAC50153AAH.
The Herma file is missing if you go into SMI mode and I have no back up copies.
I changed the Shelf Interface CPUB SI 0302 and processor B is still showing alarms.
All power supplies look ok.
How can I get the Herma file back in its directory.I am worried if I do a cold reboot the exchange might not come up.
Regards
alfasud